Struers.com.my

MATERIAL SAFETY DATA
IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING
For embedding of materialographic specimens Container size: Responsible for safety data sheet authoring: HAZARDS IDENTIFICATION
The product is not classified. However, the product contains a small amount of sensitizing substance. See section 15.
May cause minor irritation on skin contact.
The hazardous properties of the product in the environment are considered to be limited.
COMPOSITION/INFORMATION ON INGREDIENTS
The product contains: fillers and hardener.
FIRST-AID MEASURES
Move injured person into fresh air and keep person calm under observation. If uncomfortable: Seek hospital and bring these instructions.
Remove contaminated clothing immediately and wash skin with soap and water. In case of eczema or other skin disorders: Seek medical attention and bring these instructions.
Immediately flush with plenty of water for up to 15 minutes. Remove any contact lenses and open eyelids widely. If irritation persists: Seek medical attention and bring these instructions.
Immediately rinse mouth and drink plenty of water. Keep person under observation. If person becomes uncomfortable take to hospital along with these instructions. Do not induce vomiting.
MATERIAL SAFETY DATA SHEET
FIRE-FIGHTING MEASURES
Use fire-extinguishing media appropriate for surrounding materials.
Selection of respiratory protection for fire fighting: follow the general fire precautions ACCIDENTAL RELEASE MEASURES
Avoid contact with skin and eyes. Avoid inhalation of dust.
Avoid discharge into drains, water courses or onto the ground.
Remove spillage with vacuum cleaner. If not possible, collect spillage with shovel, broom or the like. For waste disposal, see section 13.
HANDLING AND STORAGE
Observe good chemical hygiene practices. Avoid inhalation of dust and contact with skin and eyes.
Store in closed original container in a dry place.
MATERIAL SAFETY DATA SHEET
EXPOSURE CONTROLS/PERSONAL PROTECTION
Provide adequate ventilation. Observe Occupational Exposure Limits and minimize the risk of inhalation of dust. Local exhaust is recommended.
Soluble) Not Otherwise Specified [PNOS]-inhalable particles Soluble) Not Otherwise Specified [PNOS]-respirable particles Personal protection equipment should be chosen according to the the CEN standards and in collaboration with the supplier of the personal protective equipment.
During dust-raising work: Dust mask/respirator.
Wear protective gloves. Nitrile gloves or rubber gloves are recommended. The most suitable glove must be chosen in consultation with the gloves supplier, who can inform about the breakthrough time of the glove material.
Goggles/face shield are recommended.
Environmental Exposure Not available.
Controls: PHYSICAL AND CHEMICAL PROPERTIES
VOC (Volatile Organic Substances): 0 g/l (calculated) MATERIAL SAFETY DATA SHEET
10. STABILITY AND REACTIVITY
Stable under normal temperature conditions.
11. TOXICOLOGICAL INFORMATION
Dust may irritate throat and respiratory system and cause coughing.
Prolonged contact may cause redness and irritation.
Dust in the eyes will cause irritation.
None known. Carcinogenicity: National Toxicology Program (NTP): No. I.A.R.C. Monographs: No. OSHA: No.
12. ECOLOGICAL INFORMATION
The product consists mainly of inorganic compounds, which are not biodegradable.
The environmental hazard of the product is considered to be limited.
No data available on bioaccumulation.
13. DISPOSAL CONSIDERATIONS
Dispose of waste and residues in accordance with local authority requirements.
14. TRANSPORT INFORMATION
The product is not covered by international regulation on the transport of dangerous goods (IMDG, IATA, ADR/RID).
MATERIAL SAFETY DATA SHEET
15. REGULATORY INFORMATION
Based on information from the manufacturer regarding the chemical composition, the product is not liable to classification, but the following labelling must be applied: Contains Dibenzoyl peroxide. May produce an allergic reaction.
Europe/USA:This Safety Data Sheet has been prepared according to the EU-regulation.
Threshold Limit Values (2008), ACGIH, by the American Conference on Governmental Industrial Hygienists.
The Code of Federal Regulation, Title 29, part 1910. Occupational Safety and Health Standards, Air contaminants (OSHA), with amendments.
16. OTHER INFORMATION
The user must be instructed in the proper work procedure and be familiar with the contents of these instructions. Risk of explosion by shock, friction, fire or other sources of ignition.
May cause sensitisation by skin contact.
The information on this data sheet represents our current data and is reliable provided that the product is used under the prescribed conditions and in accordance with the application specified on the packaging and/or in the technical guidance literature. Any other use of the product which involves using the product in combination with any other product or any other process is the responsibility of the user.
Made by DHI - Centre for Environment and Toxicology, Agern Allé 5, DK-2970 Hørsholm, Denmark.

Source: http://www.struers.com.my/resources/elements/12/88547/DUROCIT%20POWDER%20(M1201167%20-%202008-07-02).pdf